Version 5 is the first release to include a very aggressive code optimizer, optimizing for space instead of speed. The new optimizer is able to search the entire compiled program to find repeating blocks of code whereby reducing all those repeating blocks into one shared sub-routine. Optimizer is executed during the final phase of the compile which presents the ability to cross a unit boundary when performing the optimization.

To read more please visit the CCS Inc web site.

Dont forget to visit our page.

To download the CCS PIC Compiler, please visit this link for free download.

A simple open source interface of a very simple voltmetre using Arduino and Visual Studio 2010

Download link for membres of CSE ENSIT : « 0-5V Arduino Voltmetre (Open source) - CSE ENSIT»

Cette application permet de detecter tout les port com activés dans votre PC

Télécharger l'application

PICkit 3 In-Circuit Debugger

Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer. In-circuit debugging offers these benefits:

• Low cost
• Minimum of additional hardware needed for debug
• Expensive sockets or adapters are not required

The PICkit 3 can now also reprogram any PIC microcontroller

with a simple push of a button.

Note: The PICkit 3 In-Circuit Debugger/Programmer is NOT a production programmer. It should be used for development purposes only.

The MPLAB PICkit 3 allows debugging and programming of PIC^® and dsPIC^® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming™.

PICkit 3 Features

• USB (Full speed 12 Mbits/s interface to host PC)
• Real-time execution
• MPLAB IDE compatible (free copy included)
• Built-in over-voltage/short circuit monitor
• Firmware upgradeable from PC/web download
• Totally enclosed
• Supports low voltage to 2.0 volts (2.0v to 6.0v range)
• Diagnostic LEDs (power, busy, error)
• Read/write program and data memory of microcontroller
• Erase of program memory space with verification
• Freeze-peripherals at breakpoint
• Program up to 512K byte flash with the Programmer-to-Go

Header Information

Some 8-, 14- and 18-pin devices use small header boards with a special MCU for debugging. This special MCU has extra pins for PICkit 3 communication and therefore allows the use of all pins on the part for the application. The header board is not used or needed for programming. However, when debugging these devices the header must be used. See the "Header Specification" document below or see a list of current devices that use headers here.

Download « PICkit3 Programmer Application Setup v3.10.zip »

Download « PICKit 3 user-programmer user's guide.pdf »

Full proteus 8.0 (.rar) in 7 parts :

Presentation of Proteus 8 from this link : Proteus 8 on CSE ENSIT Blog
Part 1
Part 2
Part 3
Part 4
Part 5
Part 6
Part 7

------------------------

uploaded by Alain Iblex